![]() ![]() The Eddystone namespace ID cannot be entered directly in the RadBeacon configuration app. If you leave the URL blank, then it will broadcast iBeacon/Altbeacon and Eddystone UID. If you configure a URL to be broadcast, then it will broadcast iBeacon/AltBeacon and Eddystone URL. The RadBeacon Dot Eddystone beacon can be configured to advertise iBeacon/AltBeacon and either Eddystone UID or Eddystone URL. The RadBeacon USB Eddystone beacon can be configured to advertise any combination of iBeacon, AltBeacon, Eddystone UID, and Eddystone URL (although you must choose at least one). Occasionally, a configurable beacon cannot be contacted by the app on the first attempt, so you may need to try again. If it is not configurable, an alert is displayed after 15 seconds indicating that the beacon could not be contacted for configuration. If it is configurable, then the configuration detail screen for the beacon is displayed. Tap on the beacon you would like to configure. Potentially configurable Eddystone RadBeacons should be identified in the list with the Bluetooth device name "RadBeacon G". This scans for beacons for 5 seconds and displays all beacons found during the scan. To start scanning for beacons, press the SCAN button in the upper right corner on the action bar. ![]() ![]() The main beacon scan screen is displayed which should be empty. In order to start scanning for beacons, first launch the RadBeacon configuration app. For details see "How do I put beacons into configurable mode?" This can be done by power cycling the beacon. First make sure you beacons are in configurable mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |